Kanal VarnaDrains • Leaks • Thermal imaging • Plumbing
Chrome tap over a sink with no water coming out

No water in the flat in Varna: a mains fault or a problem in your own pipes?

First find out whether the water is off for the whole neighbourhood or only in your flat. Here is how to check it yourself, what ViK Varna, the local water company, deals with, what is yours, and what to do when the water comes back. If the fault is in your own pipes, we repair it every day from 06:00 to 23:00.

Our clients on video · all videos (in Bulgarian)

Quick checkNeighbours, two taps and the water meter
The boundaryUp to and including the meter assembly: ViK Varna. After it: the owner
06:00–23:00Every day, if the fault is in your pipes
Price firstWe tell you before we start
1000+ clients served 30+ years in the trade Price agreed before we start 06:00–23:00 every day
In short

No water in the flat in Varna: if the neighbouring entrances have none either, it is most likely a fault or planned cut by ViK Varna, the local water company, which publishes the times of cuts on its website. If only your flat is dry, the cause is usually in your own pipes: a closed or seized tap, a blocked filter, a burst pipe, a stopped pump or ice. If every tap is closed and the water meter's small flow wheel still turns, water is escaping after the meter. We repair faults after the water meter; we cannot switch the mains on or off or tell you when a street repair will finish. Call +359 52 993 333 or email info@kanalvarna.com — write to us in English and we reply in English.

Updated November 2026

No water in the flat: mains cut or your own pipes?

A fault or repair on the street main is dealt with only by ViK Varna; a private plumber cannot help there. If only your flat is dry, the cause is most often in the installation after the water meter: a tap, a pipe, a filter or a pump. Neighbours are the quickest test.

  1. Open two taps. Run the cold water in the kitchen and in the bathroom. If one runs and the other does not, the fault is in that tap or the pipe to it, not in the mains.
  2. Ask the neighbours. Knock next door or ask in the building's group chat. If they have no water either, it has most likely been cut for the whole entrance, street or area.
  3. Check the list of cuts. ViK Varna posts a daily list of faults and planned cuts by area on its website, with the places (sometimes the streets) and roughly when the supply is due back.
  4. Switch off the water heater if the cut is long. Turn it off at the fuse board, and switch it back on only when hot water runs steadily from the tap with no air in it.
  5. If only you are dry. Check the stop taps, the water meter and the pump, if you have one — below.

We are not ViK Varna. Kanal Varna is a private plumbing and drain firm. We do not switch the city water on or off and we do not know when a street repair will end. For that, ask ViK Varna. Call us when only your own property is dry, or when ViK Varna has told you the fault is after the meter.

What you see and where the problem probably is

A guide to the commonest cases. If two signs appear together, start with weak water everywhere: it affects more taps.

What you seeWhere the problem probably isWhat to do
No water in your flat, neighbours' flats or the next entranceViK Varna's network: a fault or planned workCheck the list of cuts; if your street is not there, report it to ViK Varna
No water at one tap onlyThe mixer tap, the small isolating valve under the sink or a blocked aeratorOpen the valve fully and rinse the aerator; if that does not help, the tap needs replacing
Weak water everywhere in your flat but normal next doorA blocked filter in your pipes, a half-open valve, old pipes or the pump in a houseCheck the valves and the filter; with a pump, see booster pump
Frosty weather and no water in your flat onlyIce in a pipe on an outside wall, on a balcony or in the water meter chamberDo not use a flame or boiling water; see frozen pipes
Little or nothing from the taps, and the water meter's flow wheel turnsWater is escaping between the meter and the tapsClose your flat's stop tap (in a block, next to your meter): probably a burst pipe in your pipes — see burst pipe

Stop taps and the water meter

If the neighbours have water and you do not, look at the taps first. Often someone has closed them — during a repair at a neighbour's, a meter change or work on the riser — and nobody opened them again.

In a block there are two meters. The main one for the building is in the meter chamber outside or just inside where the pipe enters; it is the boundary with ViK Varna. Yours is in your flat or on the stairwell. There are two stop taps too: one on the riser or entrance, in the cellar, shared by several flats — touch it only with the building manager's knowledge — and one for your flat, next to your meter, in the bathroom, in the toilet or in a cupboard on the landing. In a house the meter is usually in a chamber in the garden near the fence, and after it there is often a tap that shuts off the house. Check it is fully open.

  • Open a tap in the flat. The flow wheel is still and there is no water: water is not passing the meter — a closed tap, a blocked filter, a cut mains or ice.
  • All taps closed and the flow wheel turns: water escapes somewhere after the meter.
  • Dripping around the nuts of the house meter or the building's main meter: that is the meter assembly and belongs to ViK Varna, so report it to them. Do not break the seal yourself. If your own tap after it or your flat's meter drips, see water meter replacement.
  • A seized tap that will not turn: do not hit it or force it with a long spanner. An old tap can snap and stay open.

The flow wheel is the small wheel on the dial. It turns even with a very small flow, so it is the quickest check of whether water reaches you and whether any escapes.

Tell us whether the neighbours have water, what the meter shows and whether there is a pump — we tell you whether the fault is in your pipes and what comes next.

📞 +359 52 993 333

House or villa: pump, electricity and frost

In a house with a pump the water depends on the electricity too. If the power is off or the pump's breaker has tripped, the taps stay dry even though the mains are fine. When it freezes, houses with outside pipes lose water first — see frozen pipes. Check the fuse board and whether the pump hums. If the pump runs but does not stop, or starts and stops at short intervals, the fault is in the pump, in its tank or in a leak in the pipes — see booster pump. If you know the mains are cut and the pump is fed straight from the pipe with no tank, it is safer to switch it off until the water is back: running dry damages it.

What ViK Varna looks after and what is yours

PartWho looks after itNote
The street mainViK VarnaFaults and cuts are listed on their website
The service pipe up to and including the meter assemblyViK VarnaWith the pavement tap and the taps of the assembly
The pipe from the meter chamber to the houseThe owner of the propertyA fault in the garden after the meter is yours
Shared pipes in a block: risers, shared pipes, taps in the cellarAs a rule the owners' associationUsually treated as a shared part of the building, decided through the building manager
Pipes, taps and appliances inside the flatUsually the owner of the flatFrom the branch off the riser to the last tap

Who pays for the shared pipes in a block is for the owners' association, so start with the building manager. If ViK Varna says the leak is in the garden after the meter, the repair is the owner's, but the exact spot is found first so the whole garden is not dug up — see leak detection.

When the water comes back

After a cut, air gets into the pipes, and when the water returns it stirs up rust and sediment. For the first minutes the water spits and may be cloudy. Bring it back in this order:

  1. One cold tap first. Open cold water at one tap, in the bath or the kitchen, and let it run until it stops spluttering and clears.
  2. Hold back the machines. While the water is cloudy or rusty, do not run the washing machine or dishwasher; sediment blocks their filters. If the flow at one tap is weak, rinse its aerator, the little mesh on the spout. If the cistern does not fill, see toilet cistern repair.
  3. Water heater last. Switch it on only when hot water runs without air; an empty water heater must not be switched on.
  4. Look at the meter. Close all taps and look at the water meter: the flow wheel should be still. Check under sinks and at the meter for drips.

If the pressure after a cut is very high and something starts to drip or crack, close your flat's stop tap. Very high pressure after the meter is dealt with by a pressure reducing valve.

When to call us, and what if you are abroad

If the check shows the problem is in your own pipes, call or write when:

  • only your flat is dry although the taps are open — we look for where the water stops;
  • your flat's stop tap, or your tap after the meter assembly, will not open, will not close or drips;
  • there is a burst pipe, or the flow wheel turns with all taps closed;
  • the pump in the house will not start, will not stop or cuts in and out;
  • a pipe is frozen, or something drips after it thawed.

We work every day from 06:00 to 23:00, and we tell you when we can come. If the neighbours are dry too, the report is for ViK Varna. If you are abroad, ask a neighbour or your property manager to photograph the water meter, then send us the photo, the address and the name and phone number of whoever can open the door. For leaks already running, see emergency plumber; for planned work, plumber in Varna.

Frequently asked questions

When will the water be back, and where is the schedule?

Only ViK Varna knows. Its list of faults on its website usually gives, for each cut, the time it began and roughly when it should end. If that time has passed and there is still no water, ask ViK Varna again.

There is no water only on the upper floors. Why?

Often the mains cannot push the water that high, especially in the evening when everyone is using water, or the building's pump has stopped, if there is one. Ask the building manager. For pumps and low pressure see booster pump.

Can I open the tap before the water meter myself?

Better not. The tap before the meter is part of the service pipe that ViK Varna looks after. If it is closed, seized or leaking, report it to them and do not force it or touch the meter seal. Your own tap is after the meter assembly, and you can close and open that freely.

I'm not in Bulgaria — can you still deal with it?

Yes, if the fault is in your own pipes. Send us the address, a photo of the water meter and the contact of whoever can open the door. We arrange the visit with them, agree the price with you first, and you can pay by bank transfer. You can write to us in English and we reply in English.

Only your flat is dry?

Tell us whether the neighbours have water, what the meter shows and whether there is a pump — we tell you whether the fault is in your pipes and what comes next.

📞 +359 52 993 333

or email info@kanalvarna.com — write in English and we reply in English.

Send us a message

Leave your name and a phone number with the country code. Add your email if you prefer a written reply — write in English and we reply in English. We confirm the price before any work starts.

📞