Kanal VarnaDrains • Leaks • Thermal imaging • Plumbing
Dark wooden floorboards with white water marks

Water under the floor in Varna: laminate, parquet and a wet screed after a leak

Water from a leak rarely stays on top: it runs under the flooring and soaks into the screed. We find how far it has gone, tell you what to lift and measure until the screed has dried. Every day from 06:00 to 23:00 in Varna and along the coast.

Our clients on video · all videos (in Bulgarian)

Wet zone mappedMeter on a grid, compared with a dry area
Only the wet zoneWe say what to lift and what can stay
Measured until drySame points, until the screed has dried
Price firstWe tell you before we start
1000+ clients served 30+ years in the trade Price agreed before we start 06:00–23:00 every day
In short

If laminate has swollen or the grout lines between tiles have stayed dark after a leak, the water is most likely under the flooring and in the screed. It hardly evaporates from there, because the underlay and the film hold it in. So the leak is stopped first, then we measure how far the damp goes with a moisture meter and a thermal camera, the flooring is lifted in the wet zone and the screed dries uncovered; new flooring goes down when the measurements show it is dry. We tell you the price before we start, once you have described the job or sent photos. For walls and ceilings see drying out after a leak; the wider topic is on our mould and damp page. We work every day from 06:00 to 23:00. Call +359 52 993 333 or email info@kanalvarna.com — write to us in English and we reply in English.

Updated November 2026

Why water stays under the floor after a leak

Water from a washing machine, a dishwasher or a burst pipe runs to the lowest point and finds the joints in the flooring, the gap under the skirting board and the holes around pipes. The top looks wiped, but water is left underneath.

  • Underlay and film. The foam underlay under laminate and parquet soaks up water and the film below holds it like a tray. The flooring on top lets almost nothing evaporate.
  • The screed. Cement screed absorbs water and gives it back slowly, mainly upwards, where the flooring is.
  • Edges and skirting. There is usually an expansion gap along the walls. Water enters it, wets the foot of the wall and hides behind the skirting.
  • The next room. Screed usually runs unbroken under the doors, so a wet patch can appear where no water was spilled.

If the water reached the ceiling of the flat below, see leak from the flat above for the neighbour's side.

Signs of water under laminate, parquet or tiles

It shows in the floor, the smell and the walls — often days after the puddle was mopped up. The earlier it is noticed, the more of the floor is kept.

  • Laminate swells along the joints: board edges lift and can be felt underfoot.
  • Parquet cups, with the boards curling up at the edges, or starts to creak and come unstuck.
  • Grout lines stay dark long after cleaning, or a tile sounds hollow when tapped.
  • A damp or musty smell, especially in a closed room.
  • The skirting has swollen and the paint at the foot of the wall is dark or bubbled.
  • On a thermal camera the wet area often shows as a cooler patch, because water evaporates. Without a moisture meter this is only a suspicion.

If water keeps appearing with nothing visibly spilled, the leak may still be active: that is leak detection first.

Swollen laminate or parquet: where did the water come from?

A swollen floor says only that there was water, not where it came from. If the water is still arriving, new laminate will swell in the same place. So one question comes before replacement: was it surface water, a neighbouring room, a pipe, the heating or the ground?

PatternWhat it points to
Swelling in one zone, in front of the sink, beside the washing machine or in front of the shower; the foot of the wall nearby is dry and it does not growSpilled water or wet mopping at the surface
Swelling starts at the threshold of the bathroom or kitchen and spreads inwardsWater passing under the tiles from a trap, a shower connection or grout lines
Swelling grows although nobody spills water, the foot of the wall is damp, and the water meter moves with every tap closedA pipe in the floor or wall
Swelling around a radiator or in a line across the room, and the boiler pressure keeps fallingThe heating — see underfloor heating leak
Ground floor or house: swelling along the outer walls or across the whole room, worse in winter and after rainDamp from the foundation, not a pipe

How we find the wet zone without lifting the whole floor

We check the leak has stopped first. Then we measure on a grid across the room with a pin-type and a contactless moisture meter and compare with a dry area, photograph with the thermal camera and mark the points so we can measure the same spots later. The meter is what decides; the thermal camera only suggests where to measure. We tell you what to lift and what can stay, so that nothing is broken up unnecessarily.

Laminate, parquet, tiles: what is lifted and what is saved

Whether a floor can be saved depends on the material and how long the water stood. Laminate is the most vulnerable, solid parquet sometimes recovers, and tiles usually stay, though the floor under them dries slowest. The table is a general guide — the decision follows the measurements.

FlooringWhat happens in waterWhat is usually done
LaminateThe fibreboard core swells at the joints and does not go back. The underlay stays wet.Swollen boards are replaced; the wet zone is lifted with the underlay and film. Keep the good boards, as the same model is often no longer sold.
Solid parquetThe wood takes up water, cups, may come unstuck or crack.If not unstuck, it is sometimes left to dry slowly and sanded. Unstuck or cracked boards are replaced.
Click vinylThe vinyl copes, but the water under it has nowhere to go.Often taken apart and laid again once the screed is dry.
TilesThe tile is unharmed, but water passes through the grout and sits in the adhesive and screed.They usually stay; the floor dries slowly through the grout. Hollow or cracked tiles are replaced in place.

Before you throw boards away, photograph them and ask your insurer whether the assessor wants to see them.

Tell us what the flooring is, where the water came from and whether there is underfloor heating — we tell you the price before we start.

📞 +359 52 993 333

A wet screed: what drying depends on

A wet screed usually takes weeks to dry, and under flooring or when thick, months. The exact time cannot be given in advance, which is why we measure at the start and then at intervals, until the readings stop falling and match the dry area.

  • Thickness. A thicker screed dries disproportionately slower, because moisture from below has to pass through its whole depth.
  • Cement or anhydrite. Anhydrite screed is calcium-sulphate based, smooth and pale, often used with underfloor heating. Long wetting can soften its surface, and its dryness requirements are stricter.
  • What is underneath. A floating screed lies on insulation. Water may sit in that layer too, which is sometimes dried by machines blowing air through drilled holes. We tell you whether that is needed.
  • Air and heat. Uncovered screed dries when air carries the moisture away: airing and moderate heating. Heating with no airing only moves the moisture to cold walls and windows.

Uncovered, screed dries much faster than under flooring, underlay and film. That is why the flooring in the wet zone is lifted.

Underfloor heating after a leak: can you switch it on?

Water-based (wet) underfloor heating can speed up drying of the screed if it is brought up gradually and the room is aired. But it must first be clear that the water is not coming from the heating itself, and the flooring on top must let moisture out.

  • Pressure gauge first. If the pressure in the system falls, the leak may be in the heating pipes, which is a different job.
  • Gradually, not at full. Sudden heat can crack parquet and warp boards further. Raise the temperature in steps and air the room.
  • Electric underfloor heating. If cables or mats were in water, switch the heating off at the fuse board and do not switch it on before an electrician has checked it. The same goes for sockets reached by water.
  • The thermal camera. With the heating on, the pipes show as warm lines and the wet screed blurs the picture, so here the moisture meter decides.

When can new flooring go down?

New flooring goes down when the screed has been measured dry, not when it looks dry. Laminate, parquet or vinyl on a damp base can swell, grow mould underneath or come unstuck. Flooring makers usually give a limit for the screed's moisture, measured with the carbide (CM) method, and it is lower for anhydrite and for underfloor heating. The exact value is in the fitting instructions for your flooring, and it is worth asking the fitter how they will measure.

A moisture meter does not replace that final test, but it shows whether the screed is still drying. When the readings at the check points match the dry area and stop falling, the CM test is taken together with the floor fitter, before the flooring is laid.

Water under the floor: how we work, from visit to final measurement

  1. A conversation. Where and when the water came from, what the flooring is and whether there is underfloor heating. We tell you the price before we come.
  2. Visit and moisture map. We check the leak has stopped, measure on a grid and photograph with the thermal camera.
  3. Advice. What to lift, how to air and heat the room, and whether the screed needs drying from below.
  4. Follow-up. We come back and measure the same points until it is dry.

For what an insurer wants, see leak report for insurance.

If you are not in Bulgaria

A tenant reports swollen laminate while you are away. Send the address, photos of the floor, a note of what is above or beside it (washing machine, shower, kitchen) and the name and phone number of whoever can open the door. We arrange the visit with them, tell you the price first and tell you what we found.

Frequently asked questions

The laminate has swollen — will it flatten when it dries?

Usually not. The core is pressed wood fibre that swells at the edges and does not return to shape, so swollen boards are replaced. More important is that the water does not stay underneath: in the wet zone the underlay and film come out, otherwise the screed stays wet under the new floor.

Can the floor dry without removing the laminate?

With a little water noticed at once, sometimes, if follow-up measurements show the moisture falling. If the water stood for days or spread over a large area, hardly any escapes through laminate, underlay and film. Then lifting the wet zone usually costs less than mould and a new floor a year later.

How long does a screed take to dry after a leak?

There is no general figure that would be true. It depends on thickness, on whether the screed is cement or anhydrite, on what is under it, on whether it is uncovered and on how the room is aired and heated. So we measure at the same points at intervals, to see whether it is drying and when it will be ready for flooring.

It is wet in the next room too, where there was no water. Is that possible?

Yes. Under the doors the screed is usually continuous and water spreads through it to neighbouring rooms. So we measure not only the room with the leak but the adjoining ones, along the thresholds and walls.

I'm not in Bulgaria — can you still deal with it?

Yes. Send us the address, some photos and the contact of whoever can let us in. We arrange the visit with them, agree the price with you first, and you can pay by bank transfer. You can write to us in English and we reply in English.

Water under the floor?

Tell us what the flooring is, where the water came from and whether there is underfloor heating — we tell you the price before we start.

📞 +359 52 993 333

or email info@kanalvarna.com — write in English and we reply in English.

Send us a message

Leave your name and a phone number with the country code. Add your email if you prefer a written reply — write in English and we reply in English. We confirm the price before any work starts.

📞