Underfloor heating leak in Varna: locating the pipe without lifting the whole floor
Pressure dropping on the gauge, a wet patch on the floor, a warm spot with the heating off? The pipes are buried in the screed, so nobody can see them. We find the leak with a pressure test and a thermal camera and mark it closely enough that only a small area of floor has to be opened. Every day from 06:00 to 23:00.
Our clients on video · all videos (in Bulgarian)
If you suspect an underfloor heating leak in Varna, on the coast or in your holiday flat — the pressure keeps falling, or there is a wet or warm patch on the floor — Kanal Varna first confirms the leak with a pressure test, then pinpoints it with a thermal camera, usually to within 10–15 cm, so the screed is opened only in a small area. Underfloor heating leak diagnostics start from €40, and combined diagnostics with a written report from €55. We work every day from 06:00 to 23:00, weekends included. Call +359 52 993 333 or email info@kanalvarna.com — write to us in English and we reply in English. You pay after the job, in cash, by card or by bank transfer.
Updated November 2026How to tell underfloor heating is leaking
Water underfloor heating has pipes embedded in the screed under the floor covering, so a leak cannot be seen. The reliable way to find it without tearing up the floor is a pressure test followed by a thermal camera. The signs to look for:
- The pressure on the gauge keeps falling (for example below 1 bar on the boiler gauge) and the system needs topping up again and again.
- A wet patch on the floor, or laminate or parquet swelling.
- A warm spot with the heating off.
- A higher water or gas bill with no other explanation.
- Damp or mould in the room that you cannot explain, or a stain on the ceiling of the flat below.
If you notice any of these, do not wait. Water in the screed spreads sideways and can show up metres from the leak itself, so the wet spot is not necessarily where the pipe is damaged.
What to do now
- Note the pressure on the gauge and the date, and take a second reading a day or two later.
- If you top the system up, note when and by how much. That tells us how fast it is losing water.
- Switch the circuit off at the manifold if you know how, and keep furniture off the wet area.
- Photograph the gauge, the manifold and any damp or swollen flooring.
- If the water has come up under the floor covering or reached the flat below, tell us when you write.

Send us the gauge reading and where the floor is wet or warm — we tell you the price and when we can come.
📞 +359 52 993 333How we locate the leak
- Pressure test. We connect a hand pump and raise the pressure to 4–6 bar, closing the circuits at the manifold and testing them one by one. If the gauge drops over 15–30 minutes, that circuit is leaking. A fast fall means a large leak; a slow one means a hairline crack or a poor fitting.
- Heating on. We run the heating at maximum for 30–60 minutes. The pipes warm the screed and draw a clear thermal pattern.
- Thermal scan. We scan the floor with the camera. Properly heated pipes show as even lines; a leak shows as an area with an abnormal temperature, because the wet patch cools the surface or spreads the heat.
- Marking. We mark the spot, usually to within 10–15 cm, which is enough to open only a small area.
- Repair if you want it. Opening the screed (usually about 30 × 30 cm), repairing the pipe with a coupling, press fitting or a new section, pressure testing again, then refilling the screed and restoring the floor. You hear the price before we start.
After the inspection we can give you a written report with thermal images and photos — ask when you book, especially if you need it for your insurer. Costs: diagnostics from €40, combined diagnostics with a written report from €55. See leak detection in Varna for the other methods we use, such as the acoustic detector and moisture meter.
What the pipes are made of, and why it matters
| Pipe type | Typical weak point | What it means for a repair |
|---|---|---|
| PEX, the most common | High temperature or a mechanical knock | A coupling or press fitting repairs a single point |
| PEX-AL-PEX (multilayer) | The aluminium layer can crack if the pipe was bent many times | A local repair, usually |
| Copper, in old installations | Corrosion from aggressive water | Often several weak spots; consider replacing |
| PPR, in some budget installations | Too rigid; not recommended for underfloor heating | We assess on site whether a local repair makes sense |
A single leak can be repaired in one spot. Full replacement of the underfloor heating is worth considering when there are repeated leaks at different points, when metal pipes are badly corroded, when the system is more than 25 years old or when you are renovating the room anyway. We tell you which it is after the scan.
Empty flats and winter
Pipes in a flat that stands empty can freeze in winter, and the damage is often only discovered when the heating goes back on or when the neighbour below gets in touch. If your flat stands empty for months, ask whoever looks after it to check the pressure gauge from time to time and before the heating is switched on for the season.
If you are abroad, send us the address, the name and phone number of whoever can open the door, and a photo of the gauge. We arrange the visit with them, let you know what we found, and you can pay by bank transfer. For flats that stand empty, see also our property check page. If water has already come up under the floor, see also our mould and damp page.
Frequently asked questions
How much does it cost to find an underfloor heating leak?
Underfloor heating leak diagnostics start from €40, and combined diagnostics with a written report from €55. If you want the repair, we tell you the price before we start, once we have located the leak. See the price list.
Do you have to lift the whole floor?
No. We usually mark the spot to within 10–15 cm, and only a small area of screed, usually about 30 × 30 cm, is opened to repair the pipe.
My pressure gauge keeps falling. Is that a leak?
Likely, if it keeps dropping between top-ups. A pressure test confirms it. Note the readings and dates and send them to us.
Do I need to replace the whole system?
Not usually. One leak can be repaired in one spot. Replacement is worth considering if there are repeated leaks, badly corroded metal pipes, a system over 25 years old or a full renovation.
I'm not in Bulgaria. Can you still deal with it?
Yes. Send us the address, the contact of whoever can let us in and a photo of the gauge. We arrange the visit with them, let you know what we found, and you can pay by bank transfer.
Can I contact you in English?
Yes — write to us in English by email at info@kanalvarna.com or through the form on this page, and we reply in English. The phone number is +359 52 993 333.
Underfloor heating losing pressure?
Send us the gauge reading and where the floor is wet or warm — we tell you the price and when we can come.
📞 +359 52 993 333or email info@kanalvarna.com — write in English and we reply in English.
Send us a message
Leave your name and a phone number with the country code. Add your email if you prefer a written reply — write in English and we reply in English. We confirm the price before any work starts.