Kanal VarnaDrains • Leaks • Thermal imaging • Plumbing
Man in rubber gloves working on a basin in a tiled bathroom

Sink trap replacement in Varna: leaking, cracked or smelly traps

Water on the cupboard floor under the sink, a smell from the drain, or a trap that has cracked? Sometimes it needs a new trap, often only a new washer. We tell you which before anything is bought.

Our clients on video · all videos (in Bulgarian)

Photo firstWe tell you if a new trap is needed
Water testEvery joint checked after fitting
06:00–23:00Every day, weekends included
Pay after the jobCash, card or bank transfer
1000+ clients served 30+ years in the trade Price agreed before we start 06:00–23:00 every day
In short

For sink trap replacement in Varna, send us a photo of the pipework under the sink or bath and tell us what is happening: dripping, smelling, draining slowly or cracked. A trap (the U-bend or bottle trap) is replaced when it is cracked, corroded, has a worn thread, holds no water seal or does not fit the new sink; if it is only blocked it is cleaned, and if only the washer is old, a washer is enough. The replacement is done by the plumbers we work with and ends with a water test; a floor or linear drain in a bathroom is bigger work, done together with the tiles and waterproofing around it. We tell you the price before we start. Call +359 52 993 333 or email info@kanalvarna.com — write to us in English and we reply in English. For the rest of the planned work see plumber in Varna.

Updated November 2026

When a trap is replaced — and when it is not

A trap is the curved part of the waste pipe that keeps a little water after each use. That water is the seal: it stops drain gases coming back into the room. A trap with no water in it, because it has dried out or its shape cannot hold water, lets the smell through however new it is.

  • A crack. The plastic cup of a bottle trap splits along the thread, most often after being overtightened with pliers. The wet spot is exactly that edge.
  • Corrosion. Old metal traps rot from the inside while the chrome outside looks fine until it drips.
  • A thread that will not hold. The nut turns without tightening because the seat is worn, and a new washer does not help.
  • No water seal. Home-made joints from straight pipes and elbows do not hold water and let the smell in.
  • It does not fit. Too low for the new sink or tray, with no connection for the overflow or the washing machine.

If the trap is only blocked, it is cleaned, not replaced: that is a blocked sink trap. And if it turns out a new washer is enough, we say so. Replacing a sound trap solves nothing.

Dripping, smelling, slow, gurgling: what it usually means

What you noticeLikely causeWhat we do
Drips from the nut under the sinkLoose nut or a worn, twisted washerNew washer; new trap if the thread is damaged
The cup of a bottle trap is wetCrack along the threadA cracked cup is not glued — the trap is replaced
Bath leaks only when fullOverflow washer or the flexible overflow pipeWasher or overflow pipe replaced; the trap stays if sound
Under the bath is wet even when emptyCorroded trap or a worn connection to the drainOpened through the access hatch; trap and connection replaced
Slow draining and gurglingBlockage, or poor venting of the stackCleared first; if several fittings gurgle, we look at venting
Smell, but water runs away normallyDried-out water seal, loose connection, trap without a bendWater run and checked; new trap only if it will not hold water
Tiles around a floor drain have gone darkWater running along the seam round the drainMeasured with a moisture meter and thermal camera; if confirmed, trap and the tiles round it are redone
Man in rubber gloves working on a basin in a tiled bathroom

A single drop is hard to see. Put a dry sheet of paper under each joint and run the water: the paper gets wet where it leaks. If it still drips after a new washer, the trap is for replacement.

Which trap goes where

The trap is chosen by where it sits: under a basin, under a bath, under a shower tray or in the floor.

TrapWhereWatch out for
Bottle trapUnder a basin or kitchen sinkThe cup unscrews from below, easy to clean; needs more height
Tubular trap (a bent pipe)Under a shallow basin, little spaceNo cup for sediment; the whole bend comes apart to clean
Corrugated (flexible) trapWhere the wall pipe does not line up with the outletEasy to align, but the ribs hold grease and hair
Kitchen trap with a washing machine outletUnder a kitchen sink, often a double bowlA spigot at the side takes the machine hose
Bath trap with overflowUnder the bath, behind a panel or hatchThe overflow is a hole near the rim, a flexible pipe takes it to the trap
Shower tray trapUnder the trayShallow with a wide opening, fitted before the enclosure
Floor drainIn the bathroom floor, with a grateBuilt into the screed, with a flange for the waterproofing
Linear drainWalk-in shower, along a wall or in the middleLong channel; the floor must fall towards it along its whole length
Shower area with tiles and a linear drain along the wall

The washing machine side is covered in washing machine installation. If the trap sits under a sink that is being replaced, the sink, tap and trap are best done in one visit.

Tell us where the trap is and what happens, with a photo from underneath — we tell you if you need a new trap, and the price before we start.

📞 +359 52 993 333

Floor and linear drains are floor work

Replacing a floor or linear drain is nothing like changing a trap under a sink. The drain is cast into the screed, connected to the pipe under the slab and tied into the waterproofing of the bathroom. So it is three jobs in one — plumbing, tiling and waterproofing — in the correct order. The plumbing is done by a plumber we work with. We organise the breaking out, the new waterproofing and the tiling with the tradesmen we work with, so for you it stays one conversation.

Old cast-iron floor drain with a grate in a concrete floor

What keeps the floor dry around a new drain: a waterproofing collar or tape sealed to the drain's flange, a fall towards the drain, and enough height. In a thin old screed a linear drain sometimes does not fit, so we measure before we promise. Once the old drain is out, we try to pass a drain camera through the opening to see the pipe below it; if the head will not pass the bends, we say so and decide what to do. A drain used rarely — a second bathroom, a cellar or a terrace — dries out and smells, and there are models with a membrane that closes without water.

What we do not do: we do not drill through the building's slab and we do not touch the riser, because it is a shared part of the building. If the outlet goes through the slab and leaks towards the neighbour below, we tell you, and you may need access from the flat underneath.

When you do not need a new trap

  • It drips only at the nut. Usually an old washer or a loose joint; if the cup and thread are sound, the trap stays.
  • It drains slowly. A whole trap with standing water is taken apart and cleaned — that is unblocking, not replacement.
  • There is a smell from a shower or sink you rarely use. The water in the bend has dried out; a glass of water restores it.
  • Smell and gurgling in several places. When someone upstairs runs water and your traps empty, the cause is the ventilation of the stack — see drain smell.
  • It is wet under the sink but not from the trap. The drip may come from the tap connections or the flexible hoses.
  • It is wet around the toilet. That connection is a flexible pipe or a rubber collar, not a trap.

If it is clear from your description or photo that a washer is enough, we tell you.

Sink trap replacement: what to tell us and what the price depends on

Write to us or send photos by email to info@kanalvarna.com, and tell us:

  • where the trap is — basin, kitchen sink, bath, shower tray, floor or linear drain;
  • what is happening — dripping, smelling, draining slowly, gurgling or cracked;
  • a photo from underneath showing all the joints and the wall and floor round them;
  • whether the sink or bath has an overflow, and whether a washing machine or dishwasher is connected;
  • for a floor drain: the tiles around it, whether there is waterproofing and whether tiles will be broken;
  • whether you have already bought a trap, and which.

The price depends on the kind of trap, access to it, whether the connection or the pipe into the wall is replaced too, and, for a floor drain, on the tiles, the waterproofing and how much is broken out; for a linear drain also on the length of the channel and the height of the floor. We tell you the price before we start. An invoice is issued on request.

If you are not in Bulgaria, or the flat is let

A leaking trap in a rented flat often means water in the kitchen cupboard that nobody notices for weeks. Send us the address and the contact of the person who can open the door — tenant, cleaner or property manager — and a photo from the tenant of the space under the sink. We arrange the visit with them and agree the price with you. Pay by bank transfer if you prefer. If water has already marked a ceiling below, read leak from the flat above.

Frequently asked questions

I have already bought a trap. Will you fit it?

Yes, if it fits. Before we start we compare it with the sink outlet, the overflow and the space under it. The commonest mistake is a trap that is too tall or has no outlet for the washing machine. If it does not fit, we say so and tell you what to buy.

Plastic or metal?

Plastic does not rust and is light, so it is usual under sinks and baths. Metal is stronger against knocks and looks good under an open basin, but it is heavier and needs more careful tightening. Either does the job if the washers are right and the trap holds water; what matters most is that it fits.

How long does it take?

A trap under a sink is a short job; we tell you how long once we have seen a photo. For a floor or linear drain the time depends on the waterproofing and tile adhesive, which have to cure as the maker says.

Can a floor drain be replaced without breaking tiles?

Sometimes. If only the grate, the water seal or the insert is worn, they are changed from above. If it leaks along the seam round the drain or has no waterproofing collar, it cannot be done without opening the floor.

It smells after the trap was changed. Why?

Usually the water seal is not yet filled, the trap was fitted without a bend, or the connection to the wall is not sealed. Run the water and wait. If the smell stays, we look further: a dried-out trap in another bathroom, a loose collar, or the venting of the stack.

I'm not in Bulgaria. Can you still deal with it?

Yes. Send the address, a photo from under the sink and the contact of whoever can let us in. We agree the price with you before we start, and you can pay by bank transfer.

Can I contact you in English?

Yes — write to us in English by email at info@kanalvarna.com or through the form on this page, and we reply in English. The phone number is +359 52 993 333.

Dripping under the sink or a smell from the drain?

Tell us where the trap is and what happens, with a photo from underneath — we tell you if you need a new trap, and the price before we start.

📞 +359 52 993 333

or email info@kanalvarna.com — write in English and we reply in English.

Send us a message

Leave your name and a phone number with the country code. Add your email if you prefer a written reply — write in English and we reply in English. We confirm the price before any work starts.

📞