Kanal VarnaDrains • Leaks • Thermal imaging • Plumbing
Washing machine in a bathroom

Washing machine installation in Varna: water, drain and anti-flood protection

A new washing machine to plumb in, or one to move from the bathroom to the kitchen? The plumbers we work with connect the water and the drain, add an anti-flood valve if you want one, level the machine and run a test programme. A standard connection is from €35.

Our clients on video · all videos (in Bulgarian)

From €35A standard connection
30–60 minStandard job, longer with a new tap or hoses
06:00–23:00Every day, weekends included
Pay after the jobCash, card or bank transfer
1000+ clients served 30+ years in the trade Price agreed before we start 06:00–23:00 every day
In short

Washing machine installation in Varna starts from €35 for a standard connection; the plumbers we work with connect the cold-water hose, the drain hose, level the machine and run a test programme to check every joint. A new tap, longer hoses or an anti-flood valve are agreed with you before we start. A standard connection takes 30 to 60 minutes, and up to about an hour and a half if a new tap or longer hoses are needed. We work every day from 06:00 to 23:00. Call +359 52 993 333 or email info@kanalvarna.com — write to us in English and we reply in English. Other planned work is listed on the plumber in Varna page.

Updated November 2026

Washing machine installation in Varna: why the connection matters

The washing machine is one of the most used appliances in a home and one of the main causes of water damage in flats. A badly fitted inlet hose or a drain hose that slips out of place can flood your own flat and the one below. That is why the plumbers we work with check the water pressure, the condition of the tap and the trap, and replace what is worn.

Mains pressure acts on the inlet hose all the time, even when the machine is switched off. Rubber ages and one day splits, and a burst hose can put hundreds of litres onto a floor while nobody is in. If the flat is let or empty for weeks, this is the risk worth planning for.

Washing machine in a bathroom

What a connection includes

  1. Position. The machine goes where it is meant to stand; we check the access to water, a drain point and a socket.
  2. Cold water. The inlet hose is connected with new seals, to an angle valve, a tee or straight to the pipe, and every joint is checked for leaks.
  3. Drain. The drain hose goes to the trap under the sink, a wall outlet or its own standpipe, with a high loop so that dirty water cannot run back.
  4. Levelling and test. The feet are adjusted so the machine does not vibrate when spinning, and a short programme is run to check all joints and the drain pump.

If the trap under the sink has no outlet for a washing machine, it is replaced with one that has — see sink trap replacement. If, after a correct connection, the machine still sends water back into the sink or the floor drain, the pipe after the trap is blocked: that is a washing machine not draining.

Anti-flood protection: worth adding

An anti-flood valve, sometimes sold as an anti-flood hose, notices a change in the flow of water and closes the supply by itself. The extra cost is small compared with the damage a burst hose can do, and we recommend it for every machine, especially in a flat with neighbours below, or one that stands empty. Even machines with their own protection benefit from external protection if the inlet hose has been extended or the machine is on an upper floor.

Without one, the simplest protection is a habit: close the tap after the last wash, because a standard hose is under pressure all the time. If you or your guests forget, the anti-flood hose does it for you. Whether you need one, and what it adds to the job, we tell you before we start.

Tell us where it will stand and whether there is a tap and a drain — a standard connection is from €35, and we tell you any extra before we start.

📞 +359 52 993 333

Where the machine can go

Most machines stand in the bathroom. If there is no room, they can go in the kitchen (under the worktop), in a hall, or on a balcony if it is glazed and heated. They need a water point close by, a drain and a socket with a proper earth.

  • In the kitchen, the machine drains into the trap of the kitchen sink.
  • In a hall or another unusual place, new pipes may have to be run. We do that as well.
  • On a balcony, only a glazed one that stays above about 5°C; frozen hoses split. Running water and drain pipes to the balcony makes the job bigger, and we agree the price first.
  • A second laundry appliance stacked on the washing machine, using the maker's kit. The lighter appliance goes on top; the hoses need enough length and must not be kinked.

Machines in an upper-floor flat of an older block are worth a thought: if the flat below is let or lived in, a leak is a problem for you and for them.

Common mistakes when people do it themselves

  • The drain hose hung over the sink edge. It slips with the vibration and floods the floor, and it is unhygienic. Use a proper connection to the drain.
  • No high loop. If the hose is lower than the water in the drum, dirty water drains out during the wash and the machine never rinses well; the hose needs a bend of at least 60 cm in height.
  • Budget replacement hoses. The hose supplied is usually fine; a bargain hose from a shop is not.
  • Machine on an uneven floor. Noise, vibration and early wear of the bearings. The feet are adjusted, with anti-vibration pads if needed.
  • Hot water. Most machines have only a cold inlet and heat their own water; connecting it to hot is not advisable.

Varna water is hard, so a scale filter before the machine, or a softener product, can extend the life of the heater inside. Clean the drain pump filter every two to three months: a dirty one is among the commonest causes of machine faults.

If you are not in Bulgaria, or it is a holiday let

Send us the address, the name and phone number of whoever can open the door, and a photo of the place where the machine will stand: the tap, the drain and the socket. If the machine is delivered by the shop, tell us the day it comes. We arrange the visit with the person on site and agree the price with you; pay by bank transfer if you prefer.

For a holiday let, ask for the anti-flood valve and a tap that is easy to reach, and put a note for guests to close the tap after the last wash. If water has already gone through to the flat below, see leak from the flat above for how to deal with it.

Frequently asked questions

What does the connection include?

The cold-water hose, the drain hose to the drain, levelling the machine and a test run. If you need an extra tap or an anti-flood valve, we fit those, and we agree the price for them with you before we start.

How much does it cost to connect a washing machine?

A standard connection is from €35. A new tap, an anti-flood valve, extending the hoses or moving the machine to another room is agreed before we start, because it depends on the distance to the water and the drain.

Does the machine need its own tap?

It is better if it has one, so you can close the water quickly. If you have no separate tap, we can fit an angle valve or a tee on the pipe.

How long does it take?

A standard connection takes 30 to 60 minutes. If a new tap or longer hoses are needed, it can run to about an hour and a half.

My machine is leaking from the hose. What now?

Close the tap on the supply and unplug the machine. Check that the hose is tight and the seal is in place. If the hose is cracked or swollen, it has to be replaced. Write to us and we tell you when we can come.

I'm not in Bulgaria. Can you still deal with it?

Yes. Send the address, a photo of where the machine will stand and the contact of whoever can let us in. We agree the price with you before we start, and you can pay by bank transfer.

Can I contact you in English?

Yes — write to us in English by email at info@kanalvarna.com or through the form on this page, and we reply in English. The phone number is +359 52 993 333.

Washing machine to connect?

Tell us where it will stand and whether there is a tap and a drain — a standard connection is from €35, and we tell you any extra before we start.

📞 +359 52 993 333

or email info@kanalvarna.com — write in English and we reply in English.

Send us a message

Leave your name and a phone number with the country code. Add your email if you prefer a written reply — write in English and we reply in English. We confirm the price before any work starts.

📞